3.
Remove the screw that holds down the expansion card retention latch (1) then slide the latch up (2) and
pull it off the rear of the chassis (3).
4.
Locate the correct vacant expansion socket on the system board and the corresponding expansion slot
on the back of the computer chassis.
5.
Before installing an expansion card, remove the expansion slot cover or the existing expansion card.
NOTE:
Before removing an installed expansion card, disconnect any cables that may be attached to
the expansion card.
a.
If you are installing an expansion card in a vacant socket, you must slide one of the expansion slot
covers up and out of the chassis or use a flatblade screwdriver to pry out one of the metal shields
on the rear panel that covers the expansion slot. Be sure to remove the appropriate shield for the
expansion card you are installing.
Expansion cards
33
Содержание ProDesk 400 G2
Страница 4: ...iv Safety warning notice ...
Страница 9: ...Appendix B Statement of Volatility 144 Appendix C Specifications 146 Index 148 ix ...
Страница 10: ...x ...
Страница 57: ...10 Connect the antenna cables from the module 5 WLAN module 47 ...
