HP ProCurve Secure 7102dl, Справочное руководство

Страница: 534 / 1455

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 532
track <name>
Use the track commands to create a track as part of network monitoring. This command is also used to
enter into the Network Monitoring Track command set once a track is created. These additional commands
are covered in
Network Monitor Track Configuration Command Set on page 1347. Use the no form of this
command to delete the track.
Syntax Description
<name> Specifies the name of the track being created.
Default Values
By default, there are no tracks configured.
Functional Notes
Track objects can be associated with up to two probes to monitor their states. Upon a change in the probe
state, the probe sends an event to any track registered with the probe. In response, the track performs the
action indicated.
Associating track objects with probes can be defined through using logical AND/OR statements. Refer to
test if on page 1351 for more information.
Usage Examples
The following example creates an track called track_a :
ProCurve> enable
ProCurve# configure terminal
(config)# t ProCurve rack track_a
ProCurve(config-track-track_a)#
Technology Review
Tracks are objects created to monitor network probes for a change in their state. The tracks can be
configured to perform a specific action based upon the probe state detected. Association between a track
and a probe occurs through referencing the probe in the track’s configuration. Once the track is registered
with the probe, whenever a change occurs with the probe’s state, an event is sent to the track.
Additional configuration commands are available for creating probes. These are explained in the
Network
Monitor Probe Command Set
on page 1330.