HP ProCurve 8116fl, Руководство по установке и началу работы

Страница: 96 / 134

Troubleshooting
Restoring the Factory Default Configuration
Troub
lesho
o
ti
ng
Restoring the Factory Default
Configuration
As part of your troubleshooting process, it may become necessary to return
the switch configuration to the factory default settings. This process inter­
rupts the switch operation, clears any passwords, clears the console event log,
resets the network counters to zero, performs a complete self test, and reboots
the switch into its factory default configuration including deleting an IP
address, if one is configured.
N o t e
This process removes all switch configuration changes that you have made
from the factory default settings. This includes, for example, configuration of
VLANs, spanning tree, trunks, routing, and security. Returning the configura­
tion of these features to their factory default settings (usually disabling them)
may result in network connectivity issues.
If the switch has a valid configuration, and you are restoring the factory default
settings for a reason other than configuration problems, you should save the
switch configuration prior to performing the factory default reset. Then, after
the reset and resolution of the original problem, you can restore the saved
configuration to the switch. For both the save and restore processes, you can
use the console
copy
command. See the switch
Management and Configura­
tion Guide
that is on the documentation CD-ROM for more information on
this command.
You can restore the factory default configuration by using the switch console.
To restore the factory default configuration from the console:
■
Enter the following command at the console prompt to back up the startup
configuration:
Switch 8100fl#copy startup flash:startup.bak
■ Enter the following command to erase the setup configuration:
Switch 8100fl#erase startup
■
You can also restore the factory default configuration by entering the
following commands from the boot prompt:
PMON> set STARTUP_MODE skip_config
PMON> reset
5-8