HP ProCurve 8116fl, Руководство по установке и началу работы

Страница: 42 / 134

Inst
alli
ng t
he Pro
C
u
rve
Switch 8100fl
Installing the ProCurve Switch 8100fl
Installation Procedures
4. Installing Modules
A ProCurve Switch 8100fl supports three types of modules (shipped separately
from the chassis):
■ Switch fabric modules (half-height modules for the Switch 8108fl;
full-height modules for the Switch 8116fl) are installed in the central slots
labeled
FM . Install the primary module in slot FM-A ; install the hot
standby module into slot FM-B . (When you install a single switch fabric
module, you can use either slot FM-A or FM-B .)
■ Management modules (thicker, half-height modules) are installed in slots
labeled MM .
• If you are installing only one management module, you can install it
in either slot MM-A or MM-B .
• If you are installing two management modules, the primary
management module is the one installed in slot MM-A . The redundant
management module is the module installed in slot MM-B .
■ Interface modules (narrow half-height modules) are installed in
numbered slots ( 1-8 on the Switch 8108fl; 1-16 on the Switch 8116fl).
Be sure to install each type of module in its appropriate slot by referring to
the slot number or label, as shown in the following illustration:
Numbered slots for interface modules
MM slots for management modules
FM slots for switch fabric modules
2-16