HP ProCurve 8116fl, Руководство по установке и началу работы

Страница: 17 / 134

Introducing the ProCurve Series 8100fl Switch
Front of the Switch
10/100 Base-T Data Terminal Equipment (DTE) Port. Use the
RJ-45 port to manage a ProCurve 8100fl Switch from a management
workstation through an inband Telnet session. The RJ-45 port is configured
as a media data interface (MDI). For out-of-band console access, you can also
connect directly to the RJ-45 serial port on top of the chassis (see
page 2-27 ).
PCMCIA Flash Card. The PCMCIA card slot holds a PC flash memory card
(reserved for future software releases).
Switch Fabric Module LEDs
Switch fabric modules have two LEDs: an Active LED (on top) and a Status
LED (on bottom). The LED states are described in the following table.
Table 1-2.
Switch Fabric Module (J8729A/J8730A)
LED
Switch Fabric Module LEDs LED Color State Meaning
Active Green
Green
n/a
Flashing
Solid
Off
Negotiating active/backup switch fabric
module(s) during boot sequence.
Module is active - normal.
Module is in back up mode.
Active and
Status LEDs
Status n/a
Green
Green
Yellow/
Orange
Off
Flashing
Solid
Flashing
No power to the module.
Module is powering up and downloading
operating software.
Module is in service - normal.
Self-test failure.
Int
rod
uci
ng th
e ProCurve
Series 8100fl Switch
1-7