HP ProCurve 2810-24G, Руководство по управлению и настройке

Страница: 157 / 272

6-9
Quality of Service (QoS): Managing Bandwidth More Effectively
Introduction
If a packet is not in a VLAN-tagged port environment, then the QoS settings in
table 6-2 control only to which outbound queue the packet goes. Without VLAN
tagging, no 802.1p priority is added to the packet for downstream device use.
But if the packet is in a VLAN-tagged environment, then the above setting is
also added to the packet as an 802.1p priority for use by downstream devices
and applications (shown in table 6-3). In either case, an IP packet can also
carry a priority policy to downstream devices by using DSCP-marking in the
ToS byte.
Table 6-3. Mapping Switch QoS Priority Settings to Device Queues
QoS Types for Prioritizing Outbound Packets
The QoS types used in the switches covered in this chapter are a subset of the
types used in the Series 5300xl switches (they are referred to as “classifiers”).
Also, the 2810 switch searches for type matches in the opposite order of that
used in the 5300xl switches. (For more on QoS operation for the 5300xl
switches and the 3400cl switches, refer to the
Advanced Traffic Management
Guide for these switch models.)
N o t e O n U s i n g
M u l t i p l e
C r i t e r i a
ProCurve recommends that you configure a minimum number of the available
QoS types for prioritizing any given packet type. Increasing the number of
active type options for a packet type increases the complexity of the possible
outcomes and consumes switch resources.
Priority Setting Outbound Port
Queues in the
Switch
802.1p Priority Setting Added
to Tagged VLAN Packets
Leaving the Switch
Queue Assignment in Downstream Devices With:
8 Queues 3 Queues 2 Queues
1 Queue 1 1 (low priority) Queue 1 Queue 1
2 2 Queue 2 Queue 1
0 Queue 2 0 (normal priority) Queue 3 Queue 2
3 3 Queue 4
4 Queue 3 4 (medium priority) Queue 5 Queue 3
5 5 Queue 6 Queue 2
6 Queue 4 6 (high priority) Queue 7
7 7 Queue 8