HP ProCurve 1600M, Руководство по управлению и настройке

Страница: 142 / 690

Switch Memory and Configuration
Multiple Configuration Files
Displaying the Content of A Specific Startup-Config File
With Multiple Configuration enabled, the switch can have up to three startup­
config files. Because the
show config
command always displays the content of
the currently active startup-config file, the command extension shown below
is needed to allow viewing the contents of any other startup-config files stored
in the switch.
Syntax: show config < filename >
This command displays the content of the specified startup­
config file in the same way that the
show config
command
displays the content of the default (currently active) startup­
config file.
Changing or Overriding the Reboot Configuration
Policy
Command Page
startup-default [ primary | secondary ] config < filename > Below
boot system flash < primary | secondary > config < filename > 6-34
You can boot the switch using any available startup-config file.
Changing the Reboot Configuration Policy. For a given reboot, the
switch automatically reboots from the startup-config file assigned to the flash
location (primary or secondary) being used for the current reboot. For exam­
ple, when you first download a software version that supports multiple
configuration files and boot from the flash location of this version, the switch
copies the existing startup-config file (named
oldConfig ) into memory slot 2,
renames this file to workingConfig , and assigns workingConfig as:
■ The active configuration file
■ The configuration file to use when booting from either primary or second­
ary flash.
In this case, the switch is configured to automatically use the
workingConfig
file in memory slot 2 for all reboots.
You can use the following command to change the current policy so that the
switch automatically boots using a different startup-config file.
6-32