HP ProBook 430 G4, Руководство по техническому обслуживанию и ремонту

Страница: 51 / 120

M.2 solid-state drive
Description Spare part number
256-GB, TLC 905799-001
128-GB, TLC 905800-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in “Battery Safe mode” ( Battery Safe mode on page 30 ).
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the service door (see Service doors on page 31 ).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×4.0 screw (1) that secures the solid-state drive to the computer. (The edge
of the module opposite the slot rises away from the computer.)
2. Remove the solid-state drive (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Component replacement procedures 41