Installing Hardware Options
HP ProLiant ML530 Generation 2 Server Setup and Installation Guide
3-29
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: d-ch3 Installing Hardware Options.doc
Codename: Seattle Slew Part Number: 225579-002 Last Saved On: 1/8/03 3:00 PM
16.
Reinstall the processor air baffle:
a.
Insert the air baffle into the server. Be sure to insert the plastic tab on the air
baffle into the raised metal slot on the chassis wall (1).
b.
Tighten the thumbscrews (2).
Figure 3-23: Installing the processor air baffle
17.
Reinstall the access panel.
18.
Install the server. See Chapter 5, “Installing the Rack Server” or Chapter 6,
“Installing the Tower Server.”
19.
Power up the server. See Chapter 5, “Installing the Rack Server” or Chapter 6,
“Installing the Tower Server.”
NOTE:
The ROM sets the processing frequency during the Power-On Self-Test (POST).
20.
Be sure that the internal health LED on the front of the system is illuminated
green, indicating that the system is functioning properly. For detailed information
on LEDs, see Appendix C, “System LEDs and Switches.”
21.
If the LED indicates an error, see Appendix D, “Troubleshooting,” or refer to the
troubleshooting guide for instructions.
