Server Configuration and Utilities
Server Passwords
The
Server Passwords
menu configures the password environment of the server.
The available options are as follows:
•
•
•
•
Set Admin Password
sets a password to control access to the administrative
features of the server. When this password is set, the administrative features of
the server cannot be accessed without the correct password being entered.
Set Power-On Password
sets a password to control access to the server during
power up. When this password is set, the server cannot be powered up without
the correct password being entered.
Network Server Mode
is a security feature that protects an unattended network
server while allowing it to run after a power interruption. When set to
Disabled
,
the server operates normally. When set to
Enabled
, the following actions occur:
— The local keyboard does not function unless the power-on password is
entered.
— When a diskette is not in the diskette drive, the power-on password is
bypassed, allowing the server to start.
— When a diskette is in the diskette drive, the server does not start unless the
power-on password is entered locally.
NOTE:
Network Server Mode
cannot be enabled until a power-on password has been
established through the
Set Power-On Password
menu.
QuickLock
enables or disables the QuickLock feature. When set to
Enabled
, the
keyboard is locked by pressing the
Ctrl
+
Alt
+
L
keys. The keyboard remains
locked until the password is typed in.
NOTE:
If the password is disabled at the power-on key prompt, the QuickLock password
feature remains active until the next time the server is turned on.
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide
5-5
HP CONFIDENTIAL
Writer: Rob Weaver File Name: f-ch5 Server Configuration and Utilities.doc
Codename: Flashback Part Number: 322383-001 Last Saved On: 2/11/03 1:26 PM
