Installing and Configuring
Replacing a CD-ROM Drive
WARNING: Always wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components. Be sure the metal of the wrist
strap contacts your skin.
The flexible disk, CD-ROM, and optional disk do not have protective shields; they are
ESD sensitive. Caution must be taken when removing them to avoid electrical shock.
Install and remove connectors carefully, and avoid displacing any of the pins.
Use the following steps to replace a CD-ROM drive:
1. If the server is operating, log off all users, back up files, and power down the server.
2. Disconnect the power cord and any external cables connected to the server. If necessary,
label each one to expedite re-assembly.
3. Open the upper bezel and side panel.
4. Disconnect the power and signal cable connector from inside the side panel.
5. Press the two latches of the drive inward and, holding the disk by its sides, gently slide
the drive out of the chassis. Refer to Figure 2-6.
Figure 2-6: Removing the CD-ROM drive
6. Gently slide the new drive into the opening until the eject mechanism clicks.
7. Connect the power and signal cable to the new drive.
8. Close the upper bezel and side panel.
9. Reconnect the external cables and power cord.
10. Power up the server and return to normal operation.
HP ProLiant ML150 Server Operations and Maintenance Guide
2-9
HP CONFIDENTIAL
Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:09 AM
