13
Connector repair
This procedure includes HDMI and D-SUB connectors.
The connectors are on the main board (board part number CBPRNE7HPQ6)
The
connector’s identifiers are as follows:
Connector
Location
HDMI
CN503
D-SUB
CN101
Before repairing connectors, follow these steps:
▲
Prepare the monitor for disassembly. See Preparation for disassembly on page 10.
IMPORTANT:
• Repair Condition: Connector repair is only for out of warranty.
• Repairing must operate by professional repairers (Note) in repair center, not applicable for end
user.
• Electrostatic protection is required when component replacement is required.
• The monitor meets ROHS, please use Lead-free solder wire for soldering.
• If Connector need to replace, must check specification and part number whether match the BOM
and location.
• If connector need to replace, please insert new parts carefully because the near pin may cause
