HP J4899B, Руководство по установке и началу работы

Страница: 73 / 116

4-7
Troubleshooting
Diagnosing with the LEDs
T
rou
bl
es
h
o
ot
ing
➐
The port may be
improperly
configured, or
the port may be in
a “blocking”
state by the
normal operation
of the Spanning
Tree, LACP, or
IGMP features. Use the switch console to see if the port is part of a dynamic trunk (through the LACP
feature) or to see if Spanning Tree is enabled on the switch, and to see if the port may
have been put into a “blocking” state by those features. The
show lacp command displays
the port status for the LACP feature; the show spanning-tree command displays the port
status for Spanning Tree.
Also check the Port Status screen using the
show interfaces command to see if the port
has been configured as “disabled”.
Other switch features that may affect the port operation include VLANs and IGMP. Use
the switch console to see how the port is configured for these features.
For software troubleshooting tips, see the chapter “Troubleshooting” in the
Management
and Configuration Guide , which is on the Documentation CD-ROM that came with your
switch.
Ensure also, that the device at the other end of the connection is indicating a good link
to the switch. If it is not, the problem may be with the cabling between the devices or the
connectors on the cable.
➑
RPS or EPS is
connected but
has experienced
a fault. Refer to the ProCurve 600/610 External Power Supplies documentation.
Tip Problem Solution