HP J3138A, Руководство по установке

Страница: 48 / 104

3-18
Configuring the HP AdvanceStack Internet Router
Configuring ISDN
C
o
nfi
gurat
ion
12. Enter the dialer list command to specify the groups and protocols
permitted to access the router:
Router (config)# dialer-list groupnumber protocol protocol_type
permit
13. Configure a static route to allow connection to the target router’s LAN.
Enter the IP address and subnet mask of the target router’s LAN interface,
and the IP address of the target router’s BRI port:
Router (config)# ip route targetrouter_ipnetwork subnetmask
targetBRIport_ipaddress
14. Enter the exit command to exit global configuration mode.
15. Enter the copy running-config startup-config command to save the
configuration to NVRAM.
Example ISDN Configuration
For your reference, table 3-3 shows an example configuration for two Cisco
routers using IP over ISDN. In the example, the current router (branch1) is at
a remote site and the target router (main1) is at a central site.