Returning Damaged Equipment
If the equipment is damaged, contact your HP customer service representative immediately. The
service representative initiates appropriate action through the transport carrier or the factory and
assists you in returning the equipment.
Unloading the Server with a Lifter
WARNING!
Use caution when using a lifter. Because of the weight of the server, you must center
the server on the lifter forks before lifting it off the pallet to avoid injury.
NOTE:
HP recommends that you follow local guidelines when lifting equipment.
To unload the server from the pallet using a lifter, follow these steps:
1.
Unpack the server.
2.
Unroll the bottom corrugated tray on the side where you will place the lifter, and slide the
server as close to that edge of the pallet as possible.
3.
Break off any foam packaging that can prevent you from fully inserting the lifter under the
server.
IMPORTANT:
Do not remove the foam packaging from the corners of the server. This foam
is required to elevate the server and enable the forks of the lifter to be inserted under the
server.
4.
Insert the lifter forks under the server.
5.
Roll the lifter forward carefully until it is positioned against the side of the server.
6.
Raise the server slowly off the pallet until it clears the pallet cushions.
7.
Roll the lifter and server away from the pallet. Do not raise the server any higher than necessary
when moving it to the rack.
Installing Additional Components
This section describes how to install components into the server that are not factory integrated.
Most servers are preconfigured with all components installed prior to shipping from the HP factory.
If you do not have additional components to install, you can skip this chapter and install the server.
Removing and Replacing the Top Cover
NOTE:
When the top cover is open or removed, the chassis fan units increase to high speed to
assist cooling. When the top cover is replaced at the end of the operation, the chassis fans return
to normal speed.
Removing the Top Cover
To remove the top cover, follow these steps:
1.
Unlock the cover release lever (
). Turn the cam 90 degrees counterclockwise.
2.
Pull up on the cover release lever to disengage the top cover from the chassis (
).
NOTE:
The cover release lever also disengages the memory carrier assembly cover.
The memory carrier assembly cover can remain in place while servicing any components
except for the memory carrier assembly and the processor board assembly.
3.
Slide the cover toward the rear of the server until the tabs release from the slots in the chassis.
4.
Lift the cover off the chassis.
Installing Additional Components
11
