HP HPE ProLiant DL365 Gen10 Plus Server, Руководство пользователя

Страница: 34 / 223

Extend the server from the rack Extend the server from the rack
NOTE: NOTE:
If the cable management arm option is installed, you can extend the server without powering down the server or
disconnecting peripheral cables and power cords. These steps are only necessary with the standard cable management
solution.
Procedure Procedure
1. Power down the server.
2. Disconnect all peripheral cables and power cords.
3. Loosen the front panel thumbscrews.
4. Extend the server on the rack rails until the server rail-release latches engage.
WARNING: WARNING:
To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
WARNING: WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release latches
and sliding the server into the rack. The sliding rails could pinch your fingers.
5. After the installation or maintenance procedure, slide the server into the rack:
a. Slide the server fully into the rack.
b. Secure the server by tightening the thumbscrews.
6. Connect the peripheral cables and power cords.
Extend the server from the rack 34