HP HPE ProLiant DL365 Gen10 Plus Server, Руководство пользователя

Страница: 106 / 223

Installing an accelerator or GPU in the secondary riser cage Installing an accelerator or GPU in the secondary riser cage
Use these instructions to install accelerator options, including GPUs, in the server.
Prerequisites Prerequisites
When installing a 3/4-length GPU, a low profile type -a controller must be installed.
Before installing this option, do the following:
Be sure that the power supplies support the installation of this option. For more information, see the Hewlett Packard Enterprise Hewlett Packard Enterprise
Configurator website Configurator website.
Be sure that you have the following items:
The components included with the GPU enablement option kit
T-15 Torx screwdriver
Procedure Procedure
1. Observe the following alerts:
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server (Power down the server).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack ( Extend the server from the rack ).
b. Remove the server from the rack ( Remove the server from the rack ).
6. Remove the access panel ( Remove the access panel).
7. If installed, remove the low profile riser cage.
Installing an accelerator or GPU in the secondary riser cage 106