HP HPE FlexNetwork MSR Router Series, Руководство по настройке

Страница: 98 / 594

88
To configure the affinity attribute for an MPLS TE tunnel:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel
interface view.
interface tunnel tunnel-number
[ mode mpls-te ]
N/A
3. Set an affinity for the MPLS
TE tunnel.
mpls te affinity-attribute
attribute-value [ mask
mask-value ]
By default, the affinity is
0x00000000, and the mask is
0x00000000. The default affinity
matches all link attributes.
Configuring a setup priority and a holding priority for an MPLS TE tunnel
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel
interface view.
interface tunnel tunnel-number
[ mode mpls-te ]
N/A
3. Set a setup priority and a
holding priority for the MPLS
TE tunnel.
mpls te priority setup-priority
[ hold-priority ]
By default, the setup priority and
the holding priority are both 7 for
an MPLS TE tunnel.
Configuring an explicit path for an MPLS TE tunnel
An explicit path is a set of nodes. The relationship between any two neighboring nodes on an explicit
path can be either strict or loose.
•
Strict —The two nodes must be directly connected.
•
Loose —The two nodes can have devices in between.
When establishing an MPLS TE tunnel between areas or ASs, you must do the following:
•
Use a loose explicit path.
•
Specify the ABR or ASBR as the next hop of the path.
•
Make sure the tunnel's ingress node and the ABR or ASBR can reach each other.
To configure an explicit path for a MPLS TE tunnel:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create an explicit path and
enter its view.
explicit-path path-name
By default, no explicit path exists
on the device.
3. Enable the explicit path.
undo disable
By default, an explicit path is
enabled.
4. Add or modify a node in the
explicit path.
nexthop [ index index-number ]
ip-address [ exclude | include
[ loose | strict ] ]
By default, an explicit path does
not include any node.
You can specify the include
keyword to have the CRLSP
traverse the specified node or the
exclude keyword to have the
CRLSP bypass the specified
node.
5. Return to system view.
quit N/A
6. Enter MPLS TE tunnel
interface view.
interface tunnel tunnel-number
N/A