HP HPE FlexNetwork MSR Router Series, Руководство по настройке

Страница: 429 / 594

419
Step Command Remarks
class-name ] point-to-point link. On other types of
interfaces such as Layer 3 Ethernet
interface, VLAN interface, and Layer 3
aggregate interface, you must use the
nexthop keyword to specify the IP
address of the next hop.
Binding an AC to a cross-connect
This task is mutually exclusive with Ethernet link aggregation. If a Layer 3 interface has been added
to a link aggregation group, you cannot bind the interface to a cross-connect, and vice versa.
After you bind a Layer 3 interface to a cross-connect, packets received from the Layer 3 interface are
forwarded through the PW or another AC bound to the cross-connect.
To bind a Layer 3 interface to a non-BGP cross-connect:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter cross-connect group
view.
xconnect-group group-name N/A
3. Enter cross-connect view.
connection connection-name N/A
4. Bind the Layer 3 interface to
the cross-connect.
ac interface interface-type
interface-number
By default, no Layer 3 interface is
bound to the cross-connect.
To bind a Layer 3 interface to a BGP cross-connect:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter cross-connect group
view.
xconnect-group group-name N/A
3. Enter auto-discovery
cross-connect group view.
auto-discovery bgp N/A
4. Enter site view.
site site-id [ range range-value ]
[ default-offset
default-offset-value ]
N/A
5. Enter auto-discovery
cross-connect view.
connection remote-site-id
remote-site-id
N/A
6. Bind the Layer 3 interface to
the BGP cross-connect.
ac interface interface-type
interface-number
By default, no Layer 3 interface is
bound to the BGP cross-connect.
Configuring PW redundancy
This task includes the following configurations:
•
Create a backup PW for the primary PW.
•
Specify whether to switch traffic from the backup PW to the primary PW when the primary PW
recovers, and specify the wait time for the switchover.
•
Manually perform a PW switchover.