235
Step Command
Remarks
3.
Enable RIP on the
interface attached to
the specified network.
network
network-address
By default, RIP is disabled on
an interface.
4.
Redistribute the VPN
routes.
import-route
protocol
[
process-id
|
all-processes
|
allow-ibgp
] [
allow-direct
|
cost
cost
|
route-policy
route-policy-name
|
tag
tag
] *
By default, no routes are
redistributed into RIP.
5.
(Optional.) Configure
the default cost for
redistributed routes.
default cost
value
The default cost is 0.
Configuring OSPF between an MCE and a PE
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an OSPF process for
a VPN instance and enter
OSPF view.
ospf
[
process-id
|
router-id
router-id
|
vpn-instance
vpn-instance-name
] *
N/A
3.
Disable routing loop
detection.
vpn-instance-capability simple
By default, routing loop detection
is enabled.
You must disable routing loop
detection for a VPN OSPF
process on the MCE. Otherwise,
the MCE does not receive OSPF
routes from the PE.
4.
(Optional.) Configure the
OSPF domain ID.
domain-id
domain-id
[
secondary
]
The default domain ID is 0.
5.
Redistribute the VPN routes.
import-route
protocol
[
process-id
|
all-processes
|
allow-ibgp
] [
allow-direct
|
cost
cost
|
nssa-only
|
route-policy
route-policy-name
|
tag
tag
|
type
type
] *
By default, no routes are
redistributed into OSPF.
6.
(Optional.) Configure filtering
of advertised routes.
filter-policy
{
acl-number
|
prefix-list
prefix-list-name
}
export
[
protocol
[
process-id
] ]
By default, redistributed routes
are not filtered.
7.
(Optional.) Configure the
default parameters for
redistributed routes (cost,
route number, tag, and type).
default
{
cost
cost
|
tag
tag
|
type
type
} *
The default cost is 1, the default
tag is 1, and default type of
redistributed routes is Type-2.
8.
Create an OSPF area and
enter OSPF area view.
area
area-id
By default, no OSPF area is
created.
9.
Enable OSPF on the
interface attached to the
specified network in the area.
network
ip-address
wildcard-mask
By default, an interface neither
belongs to any area nor runs
OSPF.
Configuring IS-IS between an MCE and a PE
Step Command
Remarks
1.
Enter system view.
system-view
N/A
Содержание HPE FlexNetwork MSR Router Series
Страница 10: ...viii Index 540 ...
