HP HPE FlexNetwork MSR Router Series, Руководство по настройке

Страница: 241 / 594

231
Step Command Remarks
4. Redistribute remote site
routes advertised by the PE
into OSPF.
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ allow-direct | cost
cost | nssa-only | route-policy
route-policy-name | tag tag | type
type ] *
By default, no routes are
redistributed into OSPF.
5. Create an OSPF area and
enter OSPF area view.
area area-id
By default, no OSPF area is
created.
6. Enable OSPF on the
interface attached to the
specified network in the area.
network ip-address
wildcard-mask
By default, an interface neither
belongs to any area nor runs
OSPF.
Configuring IS-IS between an MCE and a VPN site
An IS-IS process belongs to the public network or a single VPN instance. If you create an IS-IS
process without binding it to a VPN instance, the process belongs to the public network.
Binding IS-IS processes to VPN instances can isolate routes of different VPNs. For more information
about IS-IS, see
Layer 3—IP Routing Configuration Guide .
To configure IS-IS between an MCE and a VPN site:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create an IS-IS process for a
VPN instance and enter
IS-IS view.
isis [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
MCE. On a VPN site, configure a
common IS-IS process.
3. Configure a network entity
title.
network-entity net By default, no NET is configured.
4. Create the IS-IS IPv4 unicast
address family and enter its
view.
address-family ipv4 [ unicast ]
By default, the IS-IS IPv4 unicast
address family is not created.
5. Redistribute remote site
routes advertised by the PE
into IS-IS.
import-route
protocol
[ process-id | all-processes |
allow-ibgp
] [
allow-direct
|
cost
cost | cost-type { external |
internal } | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
By default, IS-IS does not
redistribute routes from any other
routing protocol.
If you do not specify the route
level in the command, the
command redistributes routes to
the level-2 routing table by
default.
6. Return to system view.
quit N/A
7. Enter interface view.
interface interface-type
interface-number
N/A
8. Enable the IS-IS process on
the interface.
isis enable [ process-id ]
By default, no IS-IS process is
enabled on the interface.
Configuring EBGP between an MCE and a VPN site
To run EBGP between an MCE and a VPN site, you must configure a BGP peer for each VPN
instance on the MCE, and redistribute the IGP routes of each VPN instance on the VPN site.
You can configure filtering policies to filter received routes and advertised routes.
1. Configure the MCE: