HP HPE FlexNetwork 7500 series, Руководство по настройке

Страница: 99 / 592

87
Step Command Remarks
3. Set the LSA arrival interval.
lsa-arrival-interval
interval
The default setting is 1000
milliseconds.
Make sure this interval is smaller
than or equal to the interval set with
the
lsa-generation-interva l
command.
Setting the LSA generation interval
Adjust the LSA generation interval to protect network resources and routers from being overwhelmed
by LSAs at the time of frequent network changes.
For a stable network, the minimum interval is used. If network changes become frequent, the LSA
generation interval is incremented by the incremental interval × 2
n-2
for each generation until the
maximum interval is reached. The value n is the number of generation times.
To set the LSA generation interval:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf
[
process-id
|
router-id
router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Set the LSA
generation interval.
lsa-generation-interval
maximum-interval [ minimum-interval
[ incremental-interval ] ]
By default:
•
The maximum interval is 5
seconds.
•
The minimum interval is 50
milliseconds.
•
The incremental interval is 200
milliseconds.
Disabling interfaces from receiving and sending OSPF
packets
To enhance OSPF adaptability and reduce resource consumption, you can set an OSPF interface to
"silent." A silent OSPF interface blocks OSPF packets and cannot establish any OSPF neighbor
relationship. However, other interfaces on the router can still advertise direct routes of the interface in
Router LSAs.
To disable interfaces from receiving and sending routing information:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A