435
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter OSPFv3 view.
ospfv3
[
process-id
|
vpn-instance
vpn-instance-name
] *
N/A
3.
Set a bandwidth reference
value.
bandwidth-reference value
The default setting is 100 Mbps.
Setting the maximum number of OSPFv3 ECMP routes
Perform this task to implement load sharing over ECMP routes.
To set the maximum number of ECMP routes:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter OSPFv3 view.
ospfv3
[
process-id
|
vpn-instance
vpn-instance-name
] *
N/A
3.
Set the maximum number of
ECMP routes.
maximum load-balancing
number
By default, the maximum number
of ECMP routes equals the
maximum number of ECMP
routes supported by the system.
Setting a preference for OSPFv3
A router can run multiple routing protocols. The system assigns a priority for each protocol. When
these routing protocols find the same route, the route found by the protocol with the highest priority is
selected.
To set a preference for OSPFv3:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter OSPFv3 view.
ospfv3
[
process-id
|
vpn-instance
vpn-instance-name
] *
N/A
3.
Set a preference for
OSPFv3.
preference
[
ase
]
{
preference
|
route-policy
route-policy-name
} *
By default, the preference of
OSPFv3 internal routes is 10, and
the priority of OSPFv3 external
routes is 150.
Configuring OSPFv3 route redistribution
Because OSPFv3 is a link state routing protocol, it cannot directly filter LSAs to be advertised.
OSPFv3 filters only redistributed routes. Only routes that are not filtered out can be advertised in
LSAs.
Executing the
import-route
or
default-route-advertise
command on a router makes it become an
ASBR.
Содержание HPE FlexNetwork 7500 series
Страница 505: ...493 Connector N A ...
