31
Step
Command
Remarks
5.
Enter interface view.
interface interface-type
interface-number
N/A
6.
Configure a summary route.
rip summary-address
ip-address
{
mask-length
|
mask
}
By default, no summary route is
configured.
Disabling host route reception
Perform this task to disable RIPv2 from receiving host routes from the same network to save network
resources. This feature does not apply to RIPv1.
To disable RIP from receiving host routes:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIP view.
rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
3.
Disable RIP from receiving
host routes.
undo host-route
By default, RIP receives host
routes.
Advertising a default route
You can advertise a default route on all RIP interfaces in RIP view or on a specific RIP interface in
interface view. The interface view setting takes precedence over the RIP view settings.
To disable an interface from advertising a default route, use the
rip default-route no-originate
command on the interface.
To configure RIP to advertise a default route:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIP view.
rip
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
3.
Enable RIP to advertise a
default route.
default-route
{
only
|
originate
}
[
cost
cost-value
|
route-policy
route-policy-name
] *
By default, RIP does not advertise
a default route.
4.
Return to system view.
quit
N/A
5.
Enter interface view.
interface
interface-type
interface-number
N/A
6.
Configure the RIP interface
to advertise a default route.
rip default-route
{ {
only
|
originate
} [
cost
cost-value
|
route-policy route-policy-name
]
* |
no-originate
}
By default, a RIP interface can
advertise a default route if the RIP
process is enabled to advertise a
default route.
NOTE:
The router enabled to advertise a default route does not accept default routes from RIP neighbors.
Содержание HPE FlexNetwork 7500 series
Страница 505: ...493 Connector N A ...
