227
To configure an EBGP peer group by using Method 3 (IPv6 multicast address family):
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP instance view.
bgp
as-number
[
instance
instance-name
]
N/A
3.
Create an EBGP peer group.
group group-name
external
By default, no EBGP peer groups
exist.
4.
Add an IPv6 BGP peer into
the EBGP peer group.
peer
ipv6-address
[
prefix-length
]
group
group-name as-number
as-number
By default, no peers exist in the
peer group.
5.
(Optional.) Configure a
description for the peer
group.
peer
group-name
description
text
By default, no description is
configured for the peer group.
6.
Create the BGP IPv6
multicast address family and
enter its view.
address-family ipv6 multicast
By default, no BGP IPv6 multicast
address family exists.
7.
Enable the router to
exchange IPv6 unicast
routing information used for
RPF check with peers in the
specified peer group.
peer group-name enable
By default, the router cannot
exchange IPv6 unicast routing
information used for RPF check
with the peers in the group.
Specifying the source address of TCP connections
By default, BGP uses the primary IPv4/IPv6 address of the output interface in the optimal route to a
peer or peer group as the source address of TCP connections to the peer or peer group. You can
change the source address in the following scenarios:
•
If the peer's IPv4/IPv6 address belongs to an interface indirectly connected to the local router,
specify that interface as the source interface for TCP connections on the peer. For example,
interface A on the local end is directly connected to interface B on the peer. If you use the
peer
x.x.x.x
as-number
as-number
command on the local end, and x.x.x.x is not the IPv4 address of
interface B, you must do the following:
a.
Use the
peer connect-interface
command on the peer.
b.
Specify the interface whose IPv4 address is x.x.x.x as the source interface.
•
If the source interface fails on a BGP router that has multiple links to a peer, BGP must
re-establish TCP connections. To avoid this problem, use a loopback interface as the source
interface or use the IP address of a loopback interface as the source address.
•
If the BGP sessions use the IP addresses of different interfaces, specify a source address or
source interface for each peer to establish multiple BGP sessions to a router. Specify a source
address for each peer if the BGP sessions use the different addresses of the same interface.
Otherwise, the local BGP router might fail to establish a TCP connection to a peer when it uses
the optimal route to determine the source address.
To specify the source address of TCP connections (IPv4 unicast/multicast address family):
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
Содержание HPE FlexNetwork 7500 series
Страница 505: ...493 Connector N A ...
