HP flexnetwork 5510 hi series, Руководство по установке

Страница: 22 / 82

17
Figure 19 Connecting the grounding cable to a grounding strip
(1) Grounding post (2) Grounding strip
(3) Grounding cable (4) Hex nut
Connecting the grounding cable to a grounding strip (for the HPE 5510 24G 4SFP+ HI, HPE
5510 48G 4SFP+ HI, and HPE 5510 24G SFP 4SFP+ HI switches)
1.
Remove the hex nut of a grounding post on the grounding strip.
2.
Cut the grounding cable to a length required for connecting to the grounding strip.
3.
Use a wire stripper to peel 20 mm (0.79 in) of insulation sheath off the grounding cable end.
4.
Use the needle-nose pliers to bend the bare wire.
5.
Hook the grounding cable to the post on the grounding strip, and use the hex nut to secure the
cable to the post.
Figure 20 Connecting the grounding cable to a grounding strip
(1) Grounding post (2) Grounding strip
(3) Grounding cable (4) Hex nut
Grounding the switch with a grounding conductor buried in
the earth ground
If the installation site has no grounding strips, but earth ground is available, hammer a 0.5 m (1.64 ft)
or longer angle iron or steel tube into the earth ground to serve as a grounding conductor.
The dimensions of the angle iron must be a minimum of 50 × 50 × 5 mm (1.97 × 1.97 × 0.20 in). The
steel tube must be zinc-coated and its wall thickness must be a minimum of 3.5 mm (0.14 in).
Weld the yellow-green grounding cable to the angel iron or steel tube and treat the joint for corrosion
protection.
1
4 3
2
1 2
3 4