HP FlexFabric 5940, Руководство по настройке

Страница: 15 / 52

12
Step Command Remarks
routes. all-processes | allow-ibgp ]
[ allow-direct | cost cost-value |
route-policy route-policy-name | tag tag ]
*
redistributed into RIP.
Configuring OSPF between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPF process for
a VPN instance and enter
OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
3. Disable routing loop
detection.
vpn-instance-capability simple
By default, routing loop detection
is enabled.
You must disable routing loop
detection for a VPN OSPF
process on the MCE. Otherwise,
the MCE does not receive OSPF
routes from the PE.
4. Redistribute the VPN routes.
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ allow-direct | cost
cost-value | nssa-only |
route-policy route-policy-name |
tag tag | type type ] *
By default, no routes are
redistributed into OSPF.
5. Create an OSPF area and
enter OSPF area view.
area area-id By default, no OSPF areas exist.
6. Enable OSPF on the
interface attached to the
specified network in the area.
network ip-address
wildcard-mask
By default, an interface neither
belongs to any area nor runs
OSPF.
Configuring IS-IS between an MCE and a PE
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create an IS-IS
process for a VPN
instance and enter
IS-IS view.
isis
[ process-id ]
vpn-instance
vpn-instance-name
N/A
3. Configure a network
entity title.
network-entity net By default, no NET is configured.
4. Create the IS-IS IPv4
unicast address family
and enter its view.
address-family ipv4 [ unicast ]
By default, the IS-IS IPv4 unicast
address family is not created.
5. Redistribute VPN
routes.
import-route protocol [ process-id |
all-processes
|
allow-ibgp
]
[ allow-direct | cost cost-value |
cost-type
{
external
|
internal
} |
[ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name | tag
tag ] *
By default, IS-IS does not
redistribute routes from any other
routing protocol.
If you do not specify the route level
in the command, the command
redistributes routes to the level-2
routing table by default.
6. Return to system view.
quit N/A