HP EliteBook x360 1030, Руководство по техническому обслуживанию и ремонту

Страница: 63 / 102

3. Remove the touchpad cable (3).
Reverse this procedure to install the touchpad cable.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-7 Touchpad description and part numbers
Description Spare part number
For use only on computer models equipped with NFC capability M16048-001
For use only on computer models not equipped with NFC capability M16056-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly ( Preparation for disassembly on page 42 ).
2. Remove the bottom cover ( Bottom cover on page 42 ).
3. Remove the battery ( Battery on page 43 ).
Remove the touchpad:
1. Detach the touchpad cable (1) from the top cover/keyboard. (The touchpad cable is attached to the top
cover/keyboard with double-sided adhesive.)
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the cable
from the system board.
Steps 3 and 4 apply only to computer models equipped with an NFC module and cable.
3. Detach the NFC module cable (3) from the top cover/keyboard. (The NFC module cable is attached to the
top cover/keyboard with double-sided adhesive.)
ENWW Component replacement procedures 55