HP E4510-48G, Справочник по командам

Страница: 704 / 1334

4-12
Description
Use the dot1x port-control command to set the access control mode for specified or all ports.
Use the undo dot1x port-control command to restore the default.
The default access control mode is auto .
Related commands: display dot1x .
Examples
# Set the access control mode of port GigabitEthernet 1/0/1 to unauthorized-force .
<Sysname> system-view
[Sysname] dot1x port-control unauthorized-force interface GigabitEthernet 1/0/1
Or
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x port-control unauthorized-force
dot1x port-method
Syntax
In system view:
dot1x port-method { macbased | portbased } [ interface interface-list ]
undo dot1x port-method [ interface interface-list ]
In Ethernet interface view:
dot1x port-method { macbased | portbased }
undo dot1x port-method
View
System view, Ethernet interface view
Default Level
2: System level
Parameters
macbased : Specifies to use the macbased authentication method. With this method, each user of a
port must be authenticated separately, and when an authenticated user goes offline, no other users are
affected.
portbased : Specifies to use the portbased authentication method. With this method, after the first
user of a port passes authentication, all other users of the port can access the network without
authentication, and when the first user goes offline, all other users get offline at the same time.
interface interface-list : Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1-10>, where interface-type represents the port type,
interface-number represents the port number, and & <1-10> means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.