HP E4510-48G, Справочник по командам

Страница: 682 / 1334

3-8
port-number : Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the primary accounting command to specify the primary HWTACACS accounting server.
Use the undo primary accounting command to remove the configuration.
By default, no primary HWTACACS accounting server is specified.
Note that:
z
The IP addresses of the primary and secondary accounting servers cannot be the same.
Otherwise, the configuration fails.
z
The HWTACACS service port configured on the device and that of the HWTACACS server must
be consistent.
z
If you configure the command for more than one time, the last configuration takes effect.
z
You can remove an accounting server only when no active TCP connection for sending
accounting packets is using it.
Examples
# Specify the primary accounting server.
<Sysname> system-view
[Sysname] hwtacacs scheme test1
[Sysname-hwtacacs-test1] primary accounting 10.163.155.12 49
primary authentication (HWTACACS scheme view)
Syntax
primary authentication ip-address [ port-number ]
undo primary authentication
View
HWTACACS scheme view
Default Level
2: System level
Parameters
ip-address : IP address of the server, a valid unicast address in dotted decimal notation. The default is
0.0.0.0.
port-number : Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the primary authentication command to specify the primary HWTACACS authentication server.
Use the undo primary authentication command to remove the configuration.
By default, no primary HWTACACS authentication server is specified.
Note that:
z
The IP addresses of the primary and secondary authentication servers cannot be the same.
Otherwise, the configuration fails.