HP E4510-48G, Справочник по командам

Страница: 672 / 1334

2-25
Note that:
z
For real-time accounting, a NAS must transmit the accounting information of online users to the
RADIUS accounting server periodically. This command is for setting the interval.
z
The setting of the real-time accounting interval somewhat depends on the performance of the
NAS and the RADIUS server: a shorter interval requires higher performance. You are therefore
recommended to adopt a longer interval when there are a large number of users (more than 1000,
inclusive). The following table lists the recommended ratios of the interval to the number of users.
Table 2-3 Recommended ratios of the accounting interval to the number of users
Number of users Real-time accounting interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
1000 or more 15 or more
Related commands: retry realtime-accounting , radius scheme .
Examples
# Set the real-time accounting interval to 51 minutes for RADIUS scheme radius1 .
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] timer realtime-accounting 51
timer response-timeout (RADIUS scheme view)
Syntax
timer response-timeout seconds
undo timer response-timeout
View
RADIUS scheme view
Default Level
2: System level
Parameters
seconds : RADIUS server response timeout period in seconds. It ranges from 1 to 10 and defaults to 3.
Description
Use the timer response-timeout command to set the RADIUS server response timeout timer.
Use the undo timer command to restore the default.
Note that:
z
If a NAS receives no response from the RADIUS server in a period of time after sending a
RADIUS request (authentication/authorization or accounting request), it has to resend the request