HP E4510-48G, Справочник по командам

Страница: 670 / 1334

2-23
Examples
# Set the status of the secondary server in RADIUS scheme radius1 to active .
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] state secondary authentication active
stop-accounting-buffer enable (RADIUS scheme view)
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS scheme view
Default Level
2: System level
Parameters
None
Description
Use the stop-accounting-buffer enable command to enable the device to buffer stop-accounting
requests getting no responses.
Use the undo stop-accounting-buffer enable command to disable the device from buffering
stop-accounting requests getting no responses.
By default, the device is enabled to buffer stop-accounting requests getting no responses.
Since stop-accounting requests affect the charge to users, a NAS must make its best effort to send
every stop-accounting request to the RADIUS accounting servers. For each stop-accounting request
getting no response in the specified period of time, the NAS buffers and resends the packet until it
receives a response or the number of transmission retries reaches the configured limit. In the latter
case, the NAS discards the packet.
Note that you can use the commands to change the setting only when no user is using the RADIUS
scheme.
Related commands: reset stop-accounting-buffer , radius scheme , display
stop-accounting-buffer .
Examples
# In RADIUS scheme radius1 , enable the device to buffer the stop-accounting requests getting no
responses.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] stop-accounting-buffer enable