HP E4510-48G, Справочник по командам

Страница: 667 / 1334

2-20
Parameters
ip-address : IP address of the secondary authentication/authorization server, in dotted decimal notation.
The default is 0.0.0.0.
port-number : UDP port number of the secondary authentication/authorization server, which ranges
from 1 to 65535 and defaults to 1812.
Description
Use the secondary authentication command to specify the secondary RADIUS
authentication/authorization server.
Use the undo secondary authentication command to remove the configuration.
By default, no secondary RADIUS authentication/authorization server is specified.
Note that:
z
The IP addresses of the primary and secondary authentication/authorization servers cannot be
the same. Otherwise, the configuration fails.
z
The RADIUS service port configured on the device and that of the RADIUS server must be
consistent.
z
You can use the commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: key , radius scheme , state .
Examples
# Specify the secondary authentication/authorization server for RADIUS scheme radius1 .
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] secondary authentication 10.110.1.2 1812
security-policy-server
Syntax
security-policy-server ip-address
undo security-policy-server { ip-address | all }
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address : IP address of a security policy server.
all : All IP addresses
Description
Use the security-policy-server command to specify a security policy server.
Use the undo security-policy-server command to remove one or all security policy servers.