HP E4510-48G, Справочник по командам

Страница: 560 / 1334

4-4
Parameters
vlan-id: VLAN ID of the IPv6 multicast VLAN you want to assign the current port(s) to, in the range of 1
to 4094.
Description
Use the port multicast-vlan ipv6 command to assign the current port(s) to the specified IPv6
multicast VLAN.
Use the undo port multicast-vlan ipv6 command to restore the system default.
By default, a port does not belong to any IPv6 multicast VLAN.
Note that a port can belong to only one IPv6 multicast VLAN.
Examples
# Assign GigabitEthernet1/0/1 to IPv6 multicast VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet1/0/1
[Sysname- GigabitEthernet1/0/1] port multicast-vlan ipv6 100
subvlan (IPv6 multicast VLAN view)
Syntax
subvlan vlan-list
undo subvlan { all | vlan-list }
View
IPv6 multicast VLAN view
Default Level
2: System level
Parameters
vlan-list : Specifies a VLAN in the form of vlan-id , or a VLAN range in the form of start-vlan-id to
end-vlan-id , where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
all : Deletes all the sub-VLANs of the current IPv6 multicast VLAN.
Description
Use the subvlan command to configure sub-VLAN(s) for the current IPv6 multicast VLAN.
Use the undo subvlan command to remove the specified sub-VLAN(s) or all sub-VLANs from the
current IPv6 multicast VLAN.
An IPv6 multicast VLAN has no sub-VLANs by default.
Note that:
z
The VLANs to be configured as the sub-VLANs of the IPv6 multicast VLAN must exist and must
not be IPv6 multicast VLANs or sub-VLANs of another IPv6 multicast VLAN.
z
The number of sub-VLANs of the multicast VLAN must not exceed 63.