HP E4510-48G, Справочник по командам

Страница: 482 / 1334

6-1
6
Route Policy Configuration Commands
The common configuration commands of route policy are applicable to both IPv4 and IPv6.
Common Route Policy Configuration Commands
apply cost
Syntax
apply cost [ + | - ] value
undo apply cost
View
Route policy view
Default Level
2: System level
Parameters
+ : Increases a cost value.
+ : Decreases a cost value.
cost : Cost in the range 0 to 4294967295.
Description
Use the apply cost command to set a cost for routing information.
Use the undo apply cost command to remove the clause configuration.
No cost is set for routing information by default.
Related commands: if-match interface , if-match acl , if-match ip-prefix , if-match ip next-hop ,
if-match cost , if-match tag , route-policy , apply ip-address next-hop , apply tag .
Examples
# Configure node 10 in permit mode of route policy policy1 : set a cost of 120 for routing information
whose outbound interface is Vlan-interface 10.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface Vlan-interface 10