HP E4510-48G, Справочник по командам

Страница: 416 / 1334

1-7
Protocol: Direct Process ID: 0
Preference: 0 Cost: 0
NextHop: 127.0.0.1 Interface: InLoopBack0
RelyNextHop: 0.0.0.0 Neighbour: 0.0.0.0
Tunnel ID: 0x0 Label: NULL
State: Active NoAdv Age: 00h05m32s
Tag: 0
For the description of the command output above, see Table 1-2 .
display ip routing-table ip-address
Syntax
display ip routing-table ip-address [ mask-length | mask ] [ longer-match ] [ verbose ]
display ip routing-table ip-address1 { mask-length | mask } ip-address2 { mask-length | mask }
[ verbose ]
View
Any view
Default Level
1: Monitor level
Parameters
ip-address : Destination IP address, in dotted decimal format.
mask-length : IP address mask length in the range 0 to 32.
mask : IP address mask in dotted decimal format.
longer-match : Displays the route with the longest mask.
verbose : Displays detailed routing table information, including both active and inactive routes. With
this argument absent, the command displays only brief information about active routes.
Description
Use the display ip routing-table ip-address command to display information about routes to a
specified destination address.
Executing the command with different parameters yields different output:
z
display ip routing-table ip-address
The system ANDs the input destination IP address with the subnet mask in each route entry; and
ANDs the destination IP address in each route entry with its corresponding subnet mask.
If the two operations yield the same result for an entry and this entry is active, it is displayed.
z
display ip routing-table ip-address mask
The system ANDs the input destination IP address with the input subnet mask; and ANDs the
destination IP address in each route entry with the input subnet mask.
If the two operations yield the same result for an entry and the entry is active with a subnet mask less
than or equal to the input subnet mask, the entry is displayed.
Only route entries that exactly match the input destination address and mask are displayed.