HP E4510-48G, Справочник по командам

Страница: 209 / 1334

6-30
ip-subnet-end : End IP subnet index, in the range of 0 to 11. This argument must be greater than or
equal to the beginning IP subnet index.
all : Removes all the associations between VLANs and IP subnets or IP addresses.
Description
Use the ip-subnet-vlan command to associate the current VLAN with a specified IP subnet or IP
address.
Use the undo ip-subnet-vlan command to remove the association.
Note that the IP subnet or IP address cannot be a multicast network segment or a multicast address.
Related commands: display ip-subnet-vlan vlan .
Examples
# Configure VLAN 3 as an IP subnet-based VLAN and associate it with the 192.168.1.0/24 network
segment.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0
port hybrid ip-subnet-vlan vlan
Syntax
port hybrid ip-subnet-vlan vlan vlan-id
undo port hybrid ip-subnet-vlan { vlan vlan-id | all }
View
Ethernet interface view, port group view, Layer-2 aggregate interface view
Default Level
2: System level
Parameters
vlan - id : VLAN ID, in the range of 1 to 4094.
all : Specifies all VLANs.
Description
Use the port hybrid ip-subnet-vlan vlan command to associate the current Ethernet port with the
specified IP subnet-based VLAN.
Use the undo port hybrid ip-subnet-vlan vlan command to remove the association.
On an Ethernet port associated with an IP subnet-based VLAN, if the source IP address of a received
untagged packet belongs to the corresponding IP subnet, the port tags the packet with the
corresponding VLAN tag.
z
In port group view, this command applies to all ports in the port group. For information about port
groups, refer to Ethernet Interface Configuration in the Access Volume .
z
In Layer-2 aggregate interface view, this command applies to the Layer-2 aggregate interface and
all its member ports. After you perform the configuration, the system starts applying the