HP E4510-48G, Справочник по командам

Страница: 197 / 1334

6-18
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk pvid vlan 100
# Configure VLAN 100 as the default VLAN of the trunk Layer-2 aggregate interface
Bridge-aggregation 1 , assuming Bridge-aggregation 1 does not have member ports.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port trunk pvid vlan 100
# Configure VLAN 100 as the default VLAN of the trunk Layer-2 aggregate interface
Bridge-aggregation 1 . Among the member ports of the aggregation group corresponding to
Bridge-aggregation 1 , GigabitEthernet 1/0/2 is an access port and GigabitEthernet 1/0/3 is a trunk
port.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port trunk pvid vlan 100
Error: Failed to configure on interface GigabitEthernet1/0/2! This port is not a Trunk port!
The output above shows that the configuration on Bridge-aggregation 1 and the member port
GigabitEthernet 1/0/3 succeeded; the configuration on GigabitEthernet 1/0/2 failed because
GigabitEthernet 1/0/2 was not a trunk port.
MAC Address-Based VLAN Configuration Commands
display mac-vlan
Syntax
display mac-vlan { all | dynamic | mac-address mac-address | static | vlan vlan-id }
View
Any view
Default Level
1: Monitor level
Parameters
all : Displays all the MAC address-to-VLAN entries.
dynamic : Displays dynamically configured MAC address-to-VLAN entries.
mac-address mac-address : Displays the MAC address-to-VLAN entry containing the specified MAC
address.
static : Displays the statically configured MAC address-to-VLAN entries.
vlan vlan-id : Displays the MAC address-to-VLAN entries associated with the specified VLAN.
Description
Use the display mac-vlan command to display the specified MAC address-to-VLAN entries.