HP E4510-48G, Справочник по командам

Страница: 1324 / 1334

21-12
<Sysname> system-view
[Sysname] irf member 1 irf-port 1 port 1
# Bind physical IRF ports 3 and 4 to IRF port 2 of member 3, and enable IRF on the IRF port.
<Sysname> system-view
[Sysname] irf member 3 irf-port 2 port 3 4
irf switch-to
Syntax
irf switch-to member-id
View
User view
Default Level
3: Manage level
Parameters
member-id : ID of the IRF member. The member-id argument in this command cannot be the member
ID of the master. You can view the member IDs of in an IRF by using the display irf command.
Description
Use the irf switch-to command to redirect to the specified slave device, so that you can access the
slave device directly.
When you access an IRF, you actually log in to the master device. The console of the master is
displayed as the operation interface of the access terminal. After you execute this command, you are
redirected to the specified slave device, which is equal to log in to the salve directly. The operation
interface of the access terminal switches from the console of the master to that of the slave, and the
system enters the user view of the slave. You will see that the command prompt changes to the
following format: <Sysname- member ID >, for example, <Sysname-2>.
After this command is executed, the instructions that you input at the terminal will be forwarded to the
specified slave, without being processed by the local device. Currently, you can execute the following
commands on a slave:
z
display
z
quit
z
return
z
system-view
z
debugging
z
terminal debugging
z
terminal trapping
z
terminal logging
The console of the master will not time out and will not output any information. You can return to the
console of the master by pressing the Ctrl+K keys, or execute the quit or return command. The
master is therefore reactivated and is ready for outputting information.