HP E2620, Руководство по установке и началу работы

Страница: 67 / 116

4-3
Troubleshooting
Basic Troubleshooting Tips
The E2620 Switches also support Trunking , which allows multiple
network cables to be used for a single network connection without
causing a data path loop. For more information on Spanning Tree and
Trunking, see the
Management and Configuration Guide, which is on
the HP Web site at
www.hp.com/networking/support ,
(see page 1-14 ).
■ Check the port configuration. A port on your switch may not be
operating as you expect because it has been put into a “blocking” state by
Spanning Tree, GVRP (automatic VLANs), or LACP (automatic trunking).
(Note that the normal operation of the Spanning Tree, GVRP, and LACP
features may put the port in a blocking state.) Or, the port just may have
been configured as disabled through software.
Use the switch console to determine the port’s configuration and verify
that there is not an improper or undesired configuration of any of the
switch features that may be affecting the port. For more information, see
the
Management and Configuration Guide, which is on the HP Web site
at www.hp.com/networking/support , (see page 1-14 ).
For more information on possible network problems and their solutions, refer
to the technical note “Troubleshooting LAN Performance and Intermittent
Connectivity Problems”, which can be found on the HP Web site,
www.hp.com/networking/support ,
in the Reference Library section, A-Z Index.