![HP E-MSM720 Скачать руководство пользователя страница 100](http://html.mh-extra.com/html/hp/e-msm720/e-msm720_reference-manual_157754100.webp)
CLI commands
Config context
2-50
Receive rate - maximum: This is the maximum amount of incoming bandwidth that can be
consumed by the level. Traffic in excess will be buffered for short bursts, and dropped for
sustained overages.
Bandwidth levels are arranged in order of priority from Very High to Low. Priority determines
how free bandwidth is allocated once the minimum rate has been met for each level. Free
bandwidth is always assigned to the higher priority levels first.
Assigning traffic to bandwidth levels
Customer traffic is assigned to a bandwidth level on a per-VAP (VSC) basis.
Management traffic (RADIUS, SNMP, management tool admin sessions) is assigned to
bandwidth level Very High and cannot be changed.
All traffic assigned to a particular bandwidth level shares the allocated bandwidth for that
level.
New
bandwidth control normal
Supported on: E-MSM720
bandwidth control normal
<min-tx-%>
<min-rx-%>
<max-tx-%>
<max-rx-%>
Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic
classed as Normal.
New
bandwidth control very-high
Supported on: E-MSM720
bandwidth control very-high
<min-tx-%>
<min-rx-%>
<max-tx-%>
<max-rx-%>
Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic
classed as Very High.
ip route gateway
Supported on: MSM710 E-MSM720 MSM760 MSM765zl
ip route gateway
<destination>
/
<mask>
<gateway>
<[metric]>
Adds a static route.
no ip route gateway
<destination>
/
<mask>
<gateway>
<[metric]>
Removes the specified static route.
Parameters
<destination>
Traffic addressed to this IP address will be routed.
<mask>
Indicates the number of bits in the destination address that is checked for a
match.
<gateway>
Indicates the IP address of the gateway the controller will forward routed
traffic to. The gateway address must be on the same subnet as one of the
available interfaces (Internet port or LAN port).
<metrix>
Indicates the priority of a route. If two routes exist for a destination
address then the controller chooses the one with the lower metric.
Содержание E-MSM720
