
Power supply
For a list of available power supplies, see
Computer major components on page 5
.
The power supply is secured to the rear of the chassis with four screws. Two cables connect the power supply
to the system board.
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 16
2.
Remove the access panel (
).
3.
Remove the front bezel (
4.
If installed, remove the optical drive (
Removing the optical drive on page 25
)
5.
Remove the drive cage (
Removing the drive cage on page 28
)
6.
Remove the four Torx T15 screws that connect the power supply to the rear of the chassis.
7.
Disconnect the power supply cables from the PWRCPU and PWR system board connectors (1).
40
Chapter 4 Removal and replacement procedures
Содержание Desktop Pro A G2
Страница 1: ...Maintenance and Service Guide HP Desktop Pro A G2 ...
Страница 4: ...iv Safety warning notice ...