HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 441 / 458

-425
Modeler States
These three fields provide the current information for the state of the printer:
Modeler Setup
In order to use HP Designjet 3D Diagnostic Software on a network modeler,
you must first create a modeler definition. You can create modeler definitions
by clicking the
button in the main window.
A modeler definition is made complete by specifying the following:
• Modeler name (You can use any descriptive name for the modeler.)
• Modeler type
• Modeler IP address
You can delete a modeler definition by selecting the button in the main
window and then choosing the modeler to delete from the current list of
modelers.
Display Units
Select the display units by clicking the Display Units drop down list and
selecting your preferred units. You can choose to display units in inches or
millimeters. The default display unit is inches.
Printer Status
HP Designjet 3D Diagnostic Software printer status provides the ability to set
the machines serial number and detailed information about the current
mechanical state of the printer.
• Position and Temperatures
• Versions
• Travel Limits
• Material
• Door
• Setting the Serial Number
State The current printer state as reported to HP Designjet 3D Software
Solution status.
Internal State The current internal software state (e.g. sttIdle)
Home State If present, the previous internal state to which the current state will
return when complete.