HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 104 / 458

-88
3.0 Code Errors
Major Codes
NOTE: These codes are displayed on the system LCD Display.
Code Error Definition/Recommendation
01 Unknown Error No data on what error occurred. Cycle power.
02 PUC Error Path, utilities and controller development library
(Used for software testing). Cycle power.
03 No Display Process that runs LCD display generated error.
Cycle power.
04 Memory Error Single board computer experienced memory error.
Cycle power.
05 LCD Display Failed to write to LCD display board from SBC
(error will be seen in .cfg file).
1. Cycle power.
2. Replace LCD Display
06 LCD Keypad Failed to read from LCD keypad to SBC (error will
be seen in .cfg file).
1. Cycle power.
2. Replace LCD Display
07 Manager Channel Socket from manager internal manager process
was on, SBC (Software error, will not be
displayed). Cycle power.
08 Manager
Disconnected
Socket from manager internal manager process
was off, SBC (Software error, will not be
displayed)
09 Manager Send Failed to send from manager (SBC) (Software
error)
10 Command Failed Sent legal command that was rejected (exp. Move
Z command with door open). Cycle power.
11 Queue
Communication
Socket from queue process was interrupted
(broken) (Software error). Cycle power.
12 Joblog Message
Buffer
Failed to write to job log (Software error). Cycle
power.
13 Joblog File Failed to create the job log (Software error). Cycle
power.
14 Controller Abort Controller failure (See sub errors below)
15 Starting Up Failed Some part of the start up procedure failed. Cycle
power.
15.1 Starting Up Failed Verify controller is correctly gendered (gender is
the machine type) from the .CFG file. If not,
replace with a neutral gender board and perform
firmware upgrade.
16 Find Z Failed Failed to find Z limit switch. Check for obstructions
or Z switch issues.