HP Compaq dx6100 MT, Справочное руководство

Страница: 241 / 250

Service Reference Guide, dx6100 361293-003 F–1
F
Memory
The dx6100 series computers with Intel-based processors may come with either double data rate
synchronous dynamic random access memory (DDR-SDRAM) dual inline memory modules
(DIMMs) or with double data rate 2 synchronous dynamic random access memory
(DDR2-SDRAM) dual inline memory modules (DIMMs).
Ä
CAUTION:
DDR and DDR2 memory modules are not interchangeable.
DDR-SDRAM DIMMs
The memory sockets on the system board can be populated with up to four industry-standard
DIMMs. These memory module slots are populated with at least one preinstalled memory
module. To achieve the maximum memory support, you can populate the system board with up
to 4GB of memory configured in a high-performing dual channel mode.
For proper system operation, if the computer supports DDR-SDRAM DIMMs, the DIMMs must
be industry-standard 184-pin, unbuffered PC2700 333 MHz- or PC3200 400 MHz-compliant,
2.5 volt DDR-SDRAM DIMMs. The DDR-SDRAM DIMMs must also:
■
support CAS latency 2.5 or 3 (CL = 2.5 OR CL=3)
■
contain the mandatory JEDEC SPD information
In addition, the computer supports:
■
256Mbit, 512Mbit, AND 1 Gbit non-ECC memory technologies
■
single-sided and double-sided DIMMS
■
DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM
are not supported
The following processor bus frequencies are required for the system to run at the supported
memory frequencies.
If a memory frequency is paired with an unsupported processor bus frequency, the system will
run at the highest supported memory speed. For example, if a 400 MHz DIMM is paired with a
533 MHz processor bus, the system will run at 400 MHz, the highest supported memory speed.
✎
The system will not start if you install unsupported DIMMs.
Memory Frequency Required Processor Bus Frequency
333 MHz 533 MHz or 800 MHz
400 MHz 800 MHz