Removing the memory card reader
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 26
2.
Remove the access panel (
3.
Remove the front bezel (
).
4.
Release the drive by removing the screw on the side of the memory card reader, sliding the reader
to the left to loosen it, and then pulling the memory card reader part way out of the front of the
chassis.
5.
Disconnect the cable from the back of the memory card reader and if necessary remove the cable
from the clip on the side of the hard drive cage.
6.
Pull the memory card reader out of the front of the chassis.
To replace the memory card reader, reverse the removal procedures. If the cable was routed through
a clip on the hard drive cage, be sure to reroute the cable through this clip when installing the memory
card reader.
42
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
