Removing the diskette or hard disk drive
NOTE:
On some models, the primary hard disk drive is located in the internal 3.5-inch drive cage. On
other models, the primary hard disk drive is located in the external 3.5-inch drive bay as shown here.
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 26
2.
Remove the access panel (
3.
Remove the front bezel (
).
4.
Release the diskette (floppy) or hard disk drive by removing the two screws on the side of the drive,
and then slide the drive part way out of the front of the chassis.
5.
Disconnect the power and data cables from the back of the drive.
1
2
6.
Pull the drive out through the front of the chassis.
To replace the diskette or hard disk drive, reverse the removal procedures.
Removing and replacing drives
41
