HP aruba 9300-32D Series, Руководство по установке и началу работы

Страница: 29 / 57

Installing the switch | 29
Figure 2 Mounting the switch in a two-post rack (Center-of-Gravity position)
Four-Post Rack Mount Option
The Aruba 9300-32D switch can be mounted in four-post racks and cabinets by using the Aruba X474 4-
post Rack Kit (JL483C).
For safe operation, please read the mounting precautions in Installation Precautions and Guidelines on
page 23 , before mounting a switch.
The rack rails are intended for ease of installation only, do not use rails to support the switch in any
extended position. The switch must be immediately secured with screws after installation.
The 12-24 screws supplied with the four-post rack mount kit are the correct threading for standard
EIA/TIA open 19- inch racks. If installing the switch in an equipment cabinet such as a server cabinet,
use the clips and screws that came with the cabinet in place of the 12-24 screws that are supplied with
four-post rack mount kit (JL483C).
Complete step 1, and plan which holes you will be using in the cabinet and install all four clips. Then
proceed to step 2.