HP apollo 4510 gen9, Руководство по установке и настройке

Страница: 28 / 68

Installing the chassis 28
3.
Install the chassis into the J-slot on the rails, and then pull it forward.
4.
Press the Push tabs on each rail, and then slide the chassis into the rack. When the chassis stops
midway, press the push tabs on each rail to release the chassis and slide it fully into the rack.
CAUTION: Press and hold the "Push" tab on each rail until the chassis begins to slide into
the rack. Then, release the "Push" tabs and continue to slide the chassis into the rack. Press
and hold the "Push" tab on each rail again when the rails lock at a 76.2-cm (30-inch) extension.
Then, release the "Push" tabs again and finish sliding the chassis into the rack. Failure to
release the "Push" tabs may cause damage to the rails.
Install the system components into the chassis
Once the chassis is installed in the rack, begin installing the components in the chassis.
Installing a server