HP Apollo 4200 Gen9, Руководство пользователя

Страница: 22 / 193

Operations 22
Slide the front drive cages into the chassis
After performing the installation or maintenance procedure, pull and hold the front drive cage rail release
latches, and then slide the drive cages back into the chassis.
Remove a drive from the front drive cages
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack
is adequately stabilized before extending a component from the rack.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
CAUTION: Do not operate the server for long periods with the front drive cages extended.
When the front drive cages are extended while the server is powered on, do one of the
following:
• If the iLO 08-HD Max sensor reading is reporting a temperature value, monitor the status of
the front drive health/thermal LED (" Front panel LEDs and buttons " on page 7 ). When this
LED starts flashing amber, immediately slide the drive cages back into the chassis and
keep them there until the LED turns green.
• If the iLO 08-HD Max sensor reading is reporting an N/A value, monitor how long the drive
cages have been out of the chassis. Before reaching the 140 sec mark, slide the drive
cages back into the chassis and keep them there for at least 300 sec before extending them
out again.
Failure to observe this caution will result in improper airflow and insufficient cooling that can
lead to thermal damage.
CAUTION: Do not operate the server with any of the front drive cage 1 bays empty. To
maintain proper airflow and sufficient cooling in the front drive cage 1, all drive bays in this cage
should have a drive or a drive blank.
To remove the component:
1.
Back up all server data.
2.
Do one of the following: